SPECIALITY TREES GUIDE TO PLANTING ADVANCED TREES

Hole Preparation

Dig a wide, shallow hole twice the diameter of the pot but with the same depth of the pot. The hole should not be deeper than the root ball. To allow good root penetration, rough up the sides and the bottom of the hole and remove any glazing on the side of the hole. This last point is very important for both drainage and root penetration.

Tree Preparation

The root ball needs to be moist (not wet) prior to removing from the container. Gently tap the sides of the pot and carefully remove the tree from its container. Don’t pull and reef at the trunk. Matted roots on the bottom and sides of the root ball should be shaved off with a spade or knife. Doing this removes any chance of root girdling. At this time also remove any damaged roots and branches.

Planting

Place the tree carefully in the middle of the hole. Check that the root ball surface is level with the surrounding ground surface. If it is low, remove the root ball and backfill the hole until it reaches the required planting height. The expert team at Speciality Trees recommend adding an additive to the back fill soil and a mixture of wetting agent, fertiliser, water crystals and organic matter at a rate of 1lt per 100lt of hole. Speciality Trees has developed 'Complete Tree Starter' specifically for this purpose. The team also recommend using the same soil for backfill that was dug from the hole.

Mulching

Spread organic mulch over the root ball, within the basin and over the mound to a depth of 75mm. Ensure that there is no contact between the mulch and the trunk as this can cause serious disease issues. Speciality Trees suggest using a premium mulch with the ability to break down over time.

Staking

If the tree is to be staked, two or three wooden stakes (three is preferred) should be driven into the ground around the tree but outside the perimeter of the root ball. For tying, use soft flexible material such as jute webbing strips. The stakes should be removed after 6-9 months. Three stakes ensure the tree can move in the wind without restriction from any direction.

Irrigation

Irrigation is important after planting and for at least the first summer. If using drip irrigation, make sure there are at least two drippers over the root ball. Consider weaning the tree off water and not just stopping cold turkey so the tree learns to be self-reliant.

It is recommended that the root ball be kept moist for the first summer season so that roots can re-establish. This is especially critical during summer. Keep water up by watering directly into the basin over the root ball rather than around the root ball. Take care as over watering is often a more serious problem than under watering.

To understand how much water a tree needs, carefully monitor the dissipation rate of the water once the basin is full. If the water absorbs into the soil quickly, it is a sign that the tree may be dry and therefore worthy of another water. Repeat this process.

If the water pools in the basin and takes some time to dissipate into the soil, it is a sign that the soil is sufficiently wet.

For additional guidance on giving trees the best start in soil, contact the team at Speciality Trees via the links below.